Roland VersaUV LEF2-200 Service Notes page 209

Table Height Adjustment
Measuring the distance at the five points of the print area
4.
Measure the distance between the LM guide and the tabletop at the five points of the print area . (e .g . The distance of the
lower right corner shown in the figure below)
Top view
4-1.
Move the table unit in feed direction by pressing the [] [] keys so that the front line of the print area is located under
the LM guide .
4-2.
Select [SERVICE MENU] > [MOTOR MENU] > [AXIS MOVE] > [HEIGHT] .
4-3.
Set the block on the lower right corner of the print area, and move up the table by pressing the Z height keys .
3
4-4.
Move up the table until the block touches the LM guide, then remove the block .
4-5.
Move the table up 0 .1 mm and insert the block on the same place again . Repeat this step until the space between the LM
guide and the tabletop is not enough to insert the block .
1
2
1
2-68
1 . Print area
1 . Block
2 . LM guide
3 . Table
2
L EF 2-200