Installing The Spacer Bars; Installing The T4000 Mounting Hardware For An Open-Frame Rack; Figure 34: Positioning The Spacer Bar On The Rack - Juniper T4000 Hardware Manual
Hide thumbs
Also See for T4000:
- Datasheet (4 pages) ,
- Hardware manual (468 pages) ,
- Quick start manual (40 pages)
Table of Contents
Advertisement
T4000 Router Hardware Guide
Installing the Spacer Bars
Related
Documentation
Installing the T4000 Mounting Hardware for an Open-Frame Rack
70
The router is shipped with each spacer bar attached to the rear of each front-mounting
flange.
To install the spacer bars:
Remove each spacer bar by removing the screws that fasten the spacer bar to the
1.
front-mounting flange.
Place one of the spacer bars over a flange of the large shelf. Position the notch in the
2.
rear of the spacer bar so the upper part of the bar is flush with the rack rail and the
lower part is flush with the flange of the shelf (see
Insert a mounting screw into each of the nonthreaded holes in the recesses of the
3.
spacer bar to secure the spacer bar. Each hole should have a cage nut behind it.
Repeat Steps
2
and
3
for the other spacer bar.
4.
Tighten all the screws completely.
5.
Figure 34: Positioning the Spacer Bar on the Rack
Rack Requirements for the T4000 Router on page 58
Installing the T4000 Mounting Hardware for an Open-Frame Rack on page 70
In an open-frame rack, center-mounting is generally preferable to front-mounting because
the more even distribution of weight provides greater stability. If you center-mount the
Figure 34 on page
70).
Copyright © 2013, Juniper Networks, Inc.
Advertisement
Table of Contents
Troubleshooting
