Table of Contents
Advertisement
Q
Q band 33-50, 10-110
Questionable Data/Signal Status Register, 7-9
R
READ AM DET, 10-111
read error messages, 2-7, 2-29, 2-42
Reading Errors Program Comments, 7-22
Rear Panel, 11-23
rear panel, 1-8
Ref Chain, 10-112
Reference Chain Configuration, 6-1
Reference Chain Phase-Lock-Loop Bandwidth, 2-35
reference source, 4-2, 5-1
Register and Queue Contents, 7-7
Relay, 10-113
RELAY NUMBER, 10-114
RELAY STATE, 10-115
Remote Programming, 7-1
Remote Programming Commands, 12-1
Remote setup procedure, 7-11
RETUNE YTF, 10-116
RF ANALYZER output, 11-13
RF output, 11-11
RF SOURCE, 10-117
RF Source, 10-118
RF SRC PWR SET, 10-121
RF Src Pwr Set, 10-120
RFScr, 10-119
RMT indicator, 11-14
ROM version, 10-122
Routing the input to an external instrument, 2-3
Running the Application, 16-2
S
Sample HP-IB programs, 7-12
saver
connector, 1-6
Search Acquisition, 13-10
Second Gate Control, 13-65
Select a Multiplexer (Voltmeter Monitor Point), 8-5
Select Noise Performance, 6-4
Select Phase-lock-loop Bandwidth, 6-3
Select Reference Chain Phase-Lock-Loop Bandwidth, 2-35,
2-51
Select the LO's Reference Chain Phase-Lock-Loop
Bandwidth, 2-21
Select Tuning Sensitivity, 6-2
serial nr, 10-123
Service, 10-124
Service-Manual-on-a-Disk, 16-1
Set A Hardware Latch, 8-2
Set A Relay, 8-4
Set Levels, 10-125
Set MS-IB Address, 1-9
Setting HP-IB Address, 1-18
SIGNAL input, 11-15
Softkeys and Displays, 10-1
Source, 10-126
source, 4-1
Source Operation, 4-1
Specifications
Spectrum Analyzer Connection System Control, 3-40
Spectrum Analyzer Connection User Control, 3-38
SPECTRUM ANALYZER Input From 11848, 11-33
SRQ indicator, 11-16
SRQ Program Comments, 7-25
Standard Event Status Register, 7-8
State, 10-127
Status Byte Reporting Structure, 7-5
STATUS indicators, 11-17
Status Reporting
Step Recovery Diode (SRD) Comb Generator, 13-33
Sweep-to-Lock, 13-28
Switched Gain Amplifiers, 13-56
T
Technical Data, 9-1
terminations installation
Test 1 - Maximum Output Power (mW LO), 14-4
Test 2 - Phase Noise and Spurs (mW LO), 14-7
Test 3 - AM Noise and Spurs (mW LO), 14-24
Test 4 - Comb line Spurs, 14-32
Test 5 - Mixer Linearity (IF), 14-35
Test 6 - Phase Noise and Spurs, 14-39
Test 7 - AM Detector Noise Floor, 14-51
Test 8 - Phase Noise and Spurs, 14-56
Test 9 - AM Noise and Spurs, 14-68
Tips On Running the Application, 16-2
TLK indicator, 11-18
Trim, 10-128
tunable source, 5-1
Tunable Source Operation, 5-1
Tunable Source Program Comments, 7-20
TUNE OUTPUT, 11-34
Tune Sens, 10-129
TUNE SPAN OUT, 11-35
Tune the Downconverter's LO, 2-19
Tune the Source's Frequency, 2-33
Tune the Tunable Source's Frequency, 2-49
Tune-Span Generator, 13-64
Tuning Algorithm Description, 7-19
tuning sensitivity, 4-3
U
U band 40-60, 10-130
UPDATE DISPLAY, 10-131
Using colons to separate commands, 7-2
Index-iv HP 70427A/HP 70428A User's Guide
HP 71707A/70427A, 9-2
HP 7042XA, 7-4
50 OHM, 1-8
Advertisement
Table of Contents
