Table of Contents
Advertisement
Connect Cables
Figure 1-11
If HP-IB is required for your configuration, install HP-IB cable.
HP-IB Cable Installation
Plug in and power up. Verify that the unit is working:
a. Six LED's on the front panel will illuminate for about six seconds,
then blink off.
b. Screen should have a display, which will vary depending upon the
state of the instrument the last time it was used.
c. Only ACT LED should remain lit on the active instrument. If the
other LED's stay on, an error is present. (see chapter 2, Getting
Started for help reading error messages.)
Mainframe Assembly
HP 70427A/HP 70428A User's Guide 1-11
Installation
Advertisement
Table of Contents
