To Demodulate Am: If Am Detector - HP 70427A User Manual

Getting Started

To Demodulate AM: IF AM Detector

To Demodulate AM: IF AM Detector
The IF AM detector is in the signal path when the downconverter is
downconverting signals. It can be used in mm mode and μW mode (that is
MODE μW|mm μW
the softkey can have either or underlined).
mm
Make sure the AM noise mode is set to IF. To do this press the
AM Noise
softkey and look at the softkey. It must have underlined.
AM NSE IN | IF IF
Figure 2-17 AM: IF AM Display Diagram
2-16 HP 70427A/HP 70428A User's Guide