Mitsubishi Electric MR-J5-G-N1 User Manual page 150

*1 Available on servo amplifiers with firmware version D0 or later.
*2 When canceling Quick stop in the cyclic synchronous position mode (csp), cancel it after servo-off or perform position follow-up with the
controller. If Quick stop is canceled without performing position follow-up, the servo motor may suddenly accelerate.
*3 When the controller being used cannot perform follow-up in the "Quick stop active" state (during servo-on), do not use this setting value
in the cyclic synchronous position mode (csp). For information on whether the controller being used can perform follow-up in the "Quick
stop active" state, refer to the manual for the controller.
10 PDS Control Objects
148
10.4 [Quick stop option code (Obj. 605Ah)]