Electrical System; Removing The Battery; Installing The Battery - Husqvarna FC 250 EU 2015 Owner's Manual

14

ELECTRICAL SYSTEM

14.1

Removing the battery

Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep sparks and open flames away from the battery. Only charge in well-ventilated rooms.
–
In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at least 15
minutes and contact a physician.
14.2

Installing the battery

Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the seat. (
Main work
–
Pull back the negative terminal cover
battery.
–
Pull back the positive terminal cover
battery.
–
Detach rubber band
–
Lift the battery out.
M00306-10
Main work
–
Insert the battery into the battery compartment with the terminals facing to the front.
Battery (YTX5L-BS) (
–
Reconnect rubber band
Info
Contact disk
with the claws facing down.
–
Position the positive cable and mount and tighten the screw.
Guideline
Screw, battery terminal
–
Slide positive terminal cover
–
Position the negative cable and mount and tighten the screw.
Guideline
Screw, battery terminal
–
Slide negative terminal cover
M00307-10
Finishing work
–
Mount the seat. (
p. 42)

and disconnect the negative cable from the
 and disconnect the positive cable from the

from the bottom.
p. 90)

.

must be mounted between screw
M5

over the positive terminal.
M5
 over the negative terminal.
p. 43)
70
 
and cable socket
2.5 Nm (1.84 lbf ft)
2.5 Nm (1.84 lbf ft)