Nortel DMS-100 Series Maintenance Manual page 88

1-72 Maintenance overview
the MAP commands to access REX test failures
Emergency stand-alone REX test
The ESA REX tests the ability of RLCM units to enter and exit ESA. The
ESA REX also tests the ability of RLCM units to message the ESA
processor when in ESA. The ESA REX test begins after the LCM REX test
is complete.
MAP commands for manual REX tests
The XLCM diagnostics provide the capability to start a manual LCM REX
test. To initiate a manual REX test, add a REX or REXCOV parameter to
the TST command at the PM level of the MAP display. Examples of this
command are as follows:
>MAPCI;MTC;PM;POST LCM <site><frame><unit>
Note: Post the LCM
>QUERYPM
Note: Displays information about the LCM node. Feature AF5898 adds
information about the LCMCOV REX test.
To set manual control of scheduled LCM or LCMCOV REX tests when the
system posts the LCM, type
>TST REX [ON] [OFF]
Note: The system enables or disables the REX test of the posted LCM.
or
>TST COVREX [ON] [OFF]
Note: The system enables or disables the COVREX test of the posted LCM.
To set LCM REX tests for immediate performance, type
>TST REX NOW
Note: Performs LCM_REX_TEST on the posted LCM.
or
>TST COVREX NOW
Note: Performs LCMCOV_REX_TEST on the posted LCM.
297-8211-550 Standard 05.01 August 1999