How Commands, Parameters, And Responses Are Represented; Input Prompt (>); Commands And Fixed Parameters; Variables - Nortel DMS-100 Series Maintenance Manual

Outside plant access cabinet (opac)

Hide thumbs Also See for DMS-100 Series:

Table of Contents

How commands, parameters, and responses are represented

Commands, parameters, and responses in this document conform to the

following conventions.

Input prompt (>)

An input prompt (>) indicates that the information that follows is a

Commands and fixed parameters that are entered at a MAP terminal are

shown in uppercase letters:

Variables are shown in lowercase letters:

>BSY CTRL ctrl_no

The letters or numbers that the variable represents must be entered. Each

variable is explained in a list that follows the command string.

Responses correspond to the MAP display and are shown in a different type:

Damage to the backplane connector pins

Align the card before seating it, to avoid bending the

backplane connector pins. Use light thumb pressure to

align the card with the connectors. Next, use the levers on

the card to seat the card into the connectors.

Possibility of service interruption or degradation

Possible loss of service

Before continuing, confirm that you are removing the card

from the inactive unit of the peripheral module.

Subscriber service will be lost if you remove a card from

the active unit.

DMS-100 Family OPAC Maintenance Manual XPM12 and up

About this document xi