Nortel DMS-100 Series Maintenance Manual page 585

Install the jumper connectors and cables removed in step 5 onto the
replacement circuit card.
At the front of the MSP:
9 Replace fuses removed in step 4.
If Fuses
do not blow
blow (protrude)
10 Send any faulty cards for repair according to local procedure.
11 Record the date the card was replaced, the serial number of the card, and the
symptoms that prompted replacement of the card. Go to step 13.
12 Obtain further assistance in replacing this card by contacting the personnel
responsible for the next higher level of support.
13 You have completed this procedure. Return to the maintenance procedure that
directed you to this card replacement procedure, and continue as directed.
DMS-100 Family OPAC Maintenance Manual XPM12 and up
Card replacement procedures 8-219
MSP
Do
step 10
step 12
NTRX43 NTRX43
MSP
(continued) (end)