Ext Level User Interface - Nortel DMS-100 Series Maintenance Manual

ALT level
The automatic line test (ALT) is used to run specific tests on specific lines
terminating on a Star Hub. The schedule for these tests is defined by the
operating company in table ALTSCHED. These tests are available at the ALT
level of the MAP terminal. The following table lists the commands available
at this level.
Note: The commands at the ALT level that involve specific tests (SDIAG,
DIAG, LIT, CKTTST, and BAL) are used to set the schedule to run these
tests. The actual running of these tests occurs according to the schedule set.
Table 6-23 ALT level commands
Command
QUIT
POST
ALTINFO
SDIAG
DIAG (see note)
LIT (see note)
BAL
CKTTST
LCDCUT

EXT level user interface

The EXT MAP level is used to track active FSP alarms. By entering the EXT
MAP level and typing the command string LIST CRIT, LIST MAJ, LIST MIN,
or LIST NOALM, active alarms are listed. Active Star Hub signal distribution
(SD) points are displayed by typing DISP SDALARM at the EXT MAP level.
The following figure illustrates the EXT level example of an FSP alarm seen
through the EXT level.
Star Remote System user interface 6-41
Supported?
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
DMS-100 Family NA100 Star Remote System XPM15 and up
Configuration dependent?
No
No
No
No
Yes
Yes
No
No
No