Nortel DMS-100 Series Maintenance Manual page 131

• fault indicators
• REX test maintenance record
• MAP commands to access REX test failures
ESA REX test
The ESA REX tests the ability of Hub units to enter and exit ESA. The ESA
REX test begins after the LCM REX test completes.
MAP commands for manual REX tests
XLCM diagnostics provide the capability to perform a manual LCM REX test.
A manual REX test is done by adding a REX parameter to the TST command
at the PM level of the MAP display. Examples of this command are as follows.
To post the LCM, type
>MAPCI;MTC;PM;POST LCM <site><frame><unit>
and press the Enter key.
To display information about the LCM node, type
>QUERYPM
and press the Enter key.
When the LCM is posted, to manually enable or disable scheduled LCM or
LCMCOV REX tests, type
>TST REX [ON] [OFF][QUERY]
and press the Enter key.
To start LCM REX tests on the posted LCM, type
>TST REX NOW
and press the Enter key.
Example of a MAP response:
REM1 00 0 will be put into takeover mode during the REX
Do you want to continue with the REX test
Please confirm ("YES", "Y", "NO", or "N")
Line concentrating module and ESA-independent REX test
The scheduler starts REX tests on an LCM and, when completed, the ESA
REX test is started. A manually started LCM REX test does not perform an
Star Remote System automatic maintenance 4-31
DMS-100 Family NA100 Star Remote System XPM15 and up