Nortel DMS-100 Series Maintenance Manual page 585

Star Remote System routine maintenance procedures
High temperature alarm test
At the SRMO and SRME site
1 Activate the high-temperature alarm by blowing hot air, from a heat gun or a
blow dryer, at the high-temperature sensors. The sensors are at the top of
the LMU.
At the MAP terminal
2 Check that the alarm generates.
If the alarm
generates
does not generate
3 Contact your maintenance support group.
4 You have correctly completed this procedure.
High temperature alarm test
DMS-100 Family NA100 Star Remote System XPM15 and up
SRMO and SRME
Do
step 4
step 3
13-27
(end)