Nortel DMS-100 Series Maintenance Manual page 527

Replacing an NTTR77 card in a STAR
Proceed only if you have been directed to this card replacement
procedure from a step in a maintenance procedure, are using the
procedure for verifying or accepting cards, or have been directed to this
procedure by your maintenance support group.
At your current location
1
Get a replacement card. Make sure the replacement card has the same
product equipment code (PEC), including suffix, as the card that is to be
removed.
2 If you were directed to this procedure from another maintenance procedure,
go to step 6; otherwise, continue with step 3.
At the MAP display
3 To access the PM level and post the STAR, type
>MAPCI;MTC;PM;POST STAR site frame unit
and press the Enter key.
where
site
is the site name of the STAR (alphanumeric)
frame
is the frame number of the STAR (0-511)
unit
is 0 for the STAR
Star Remote System card replacement procedures
ATTENTION
CAUTION
Loss of service
This procedure includes directions to manually busy one or
more peripheral module (PM) units. Since manually busying
a PM unit can cause service degradation, perform this
procedure only if necessary to restore out-of-service
components. Otherwise, carry out this procedure during
periods of low traffic.
DMS-100 Family NA100 Star Remote System XPM15 and up
NTTR77
in a STAR
(continued)
12-179