Nortel DMS-100 Series Maintenance Manual page 554

12-206 Star Remote System card replacement procedures
Replacing a line card
STAR or RLD
(continued)
Line card insertion /
withdrawal tool for
3-inch cards
6-inch cards
Card removal tool for
3-4 inch cards
Note: For 4-inch or larger cards, use the large grip tool ITA9953.
2
3
297-8353-550 Standard 05.01 March 2001
shown in the following table.
Apparatus code
QTH56A
QTH58A
Note: A card removal tool is required for removing cards from line
drawers. A description of this tool follows.
Apparatus code
QTH57A
Locate the line drawer or RLD containing the line card to be removed.
Open the line drawer or RLD to prepare to remove the faulty card by following
the steps below:
a Face the drawer shelf and grasp the handle at the bottom of the drawer
with the right hand.
b Push up on the drawer latch with your thumb and pull the drawer out until
fully withdrawn. It is fully withdrawn when the drawer stop, at the top,
prevents further travel.
c Ensure that a card shroud and line card extractor are available.
Common product code
A0298291
A0313317
Common product code
A0298292