Nortel DMS-100 Series Maintenance Manual page 220

7-16 Star Remote System manual maintenance
Table 7-13 Star Module log reports (Sheet 3 of 4)
Log
report Reason for output
ISDN101 Subscriber loop is not
available
ISDN102 Terminal endpoint
identifier (TEI) removed
from service
ISDN103 RLD Bd-channel state
change
ISDN106 ISDN D-channel layer 1
failure
ISDN107 TEI restore failed
297-8353-550 Standard 05.01 March 2001
Meaning
The subscriber loop is not
available for message traffic.
The RLD detects a duplicate
TEI on the same loop and has
removed it from service.
Manual action has changed
the state of the RLD
Bd-channel. The reason for
the new state is displayed only
for SysB.
The ISDN subsystem
generated this log report when
layer 1 of the specified
D-channel fails and the fail flag
is set.
This log report is output when
the system fails to restore a
TEI.
Action
Check the following:
• Verify the data in
tables LTDEF and
LTMAP related to the
RLD and LEN in the
log report. Correct
any errors.
• Check other log
reports related to the
RLD or LEN with the
problem.
• Make sure the RLD
has the correct load
and reload if
necessary.
• Busy and RTS the
RLD.
Restore the TEI using the
TEI command at the
LTPDATA level of the
MAP. If the duplicate TEI
remains, the RLD audit
will remove the TEI from
service.
If the Bd-channel state
changes to SysB, check
the reason and try to fix
the problem.
Determine the reason of
the failure and contact
the next level of
maintenance.
Determine the reason of
the failure and contact
the next level of
maintenance.