Nortel DMS-100 Series Maintenance Manual page 364

12-16 Star Remote System card replacement procedures
NT6X20
in a STAR or RLD
Replacing an NT6X20 card in a STAR or RLD
At your current location
1
At the MAP terminal
2
3
4
5
297-8353-550 Standard 05.01 March 2001
(continued)
Get a replacement card. Make sure the replacement card has the same
product equipment code (PEC), including suffix, as the card that is to be
removed.
To access the LTP level of the MAP terminal and post the line associated with
the card to be replaced, type
>MAPCI;MTC;LNS;LTP;POST L site frame unit lsg ckt
and press the Enter key.
where
site
is the name of the site where the STAR is located
frame
is the frame number of the STAR with the faulty card
unit
is 0 for the STAR
lsg
is the number of the line subgroup with the faulty card (0-35)
ckt
is the number of the circuit associated with the faulty card (0-31)
Example of a MAP response:
LCC PTY RNG .....LEN.......... DN
RES REM1 00 0 03 03
Check the status of the posted line.
If the line status is
manual busy (ManB)
not ManB
To busy the line, type
>BSY
and press the Enter key.
Go to the common replacing a line card procedure in this document. When
you have completed the procedure, return to this point.
STA F S LTA TE RESULT
7213355 MB
Do
step 5
step 4