ACLI quick reference
ACLI command modes
ACLI provides four command modes. You must enter the correct mode to perform certain
functions. For more information about ACLI, see
The following is a list of ACLI command modes:
• User EXEC (exec mode)
• Privileged EXEC (privExec mode)
• Global Configuration (config mode)
• Interface Configuration (config-if mode)
Use the factory default configuration
Perform the commands in the following table to restart the switch using the factory default
configuration.
exit
boot default
restore factory-default [-y]
Configure the management IP address
Perform the commands in the following table to configure and verify the Management IP
Address.
ip address
ip default-gateway
gateway IP>
ping
<default gateway IP>
74
Fundamentals
Command
Command
<IP>
<mask>
netmask
<default
Comments? infodev@avaya.com
ACLI concepts
Purpose
Exit the configuration mode.
Return a switch, or switches, to factory
default configuration.
Return a switch, or switches, to factory
default configuration where [-y] instructs the
switch not to prompt for confirmation.
Purpose
Set the management IP and mask.
Set the default gateway IP address.
Verify connectivity.
on page 19.
December 2011