How To Set Up The Launch Compensation Function - Fluke Versiv Series User Manual

Versiv Series Cabling Certification Product Family
Users Manual

How to Set Up the Launch Compensation Function

204
Find Quality Products Online at:
Select launch and tail cords that have the same type of fiber
1
as the fiber you will test.
On the home screen, tap the test setup panel. On the CHANGE
2
TEST screen, select an OTDR test to change, then tap EDIT. Or
to set up a new OTDR test, tap NEW TEST then tap Auto OTDR,
Manual OTDR, or DataCenter OTDR.
On the TEST SETUP screen, tap the Launch Compensation control
3
to set it to On.
On the TEST SETUP screen, make sure the Fiber Type is correct.
4
Change it if necessary.
On the TEST SETUP screen, tap SAVE.
5
On the home screen, tap SET COMP.
6
On the SET LAUNCH METHOD screen tap the type of
7
compensation you want to do.
Clean and inspect the OTDR port and the launch/tail cord
8
connectors.
Make the connections for the type of compensation you
9
selected, as shown on the SET LAUNCH METHOD screen.
10 Tap SET.
11 When the SET LAUNCH COMP screen shows, select the event or
events that are the end of the launch cord and the start of the
tail cord (if you used a tail cord).
12 Tap SAVE.
Figure 84 shows an example of an OTDR trace with launch and
tail markers enabled.
If you change the launch or tail cord, do the
compensation procedure again.
GlobalTestSupply
www.
Note
.com
sales@GlobalTestSupply.com