Installation; Introduction; Average Installation Time; Installation Warnings - GE LOGIQ 500 Service Manual

GE MEDICAL SYSTEMS
REV 5
2–2 INSTALLATION
2–2–1 Introduction
This section contains many of the procedures required to install the LOGIQ 500 console.
2–2–2 Average Installation Time
The LOGIQ 500 has been designed to be installed and checked out by an experienced service technician in approxi-
mately four hours. LOGIQ 500 consoles with optional equipment may take slightly longer.
2–2–3 Installation Warnings
1. Since the LOGIQ 500 weighs approximately 397 lbs (180 kg) without options, preferably two people should un-
pack it. Two people are also preferable for installing any additional bulky items.
2. There are no operator serviceable components. To prevent shock, do not remove any covers or panels. Should
problems or malfunctions occur, unplug the power cord. Only qualified service personnel should carry out servic-
ing and troubleshooting.
For information regarding packing labels, refer to ILLUSTRATION 2–3, LABELS ON PACKAGE.
3. After being transported, the unit may be very cold or hot. If this is the case, allow the unit to acclimate before you
turn it on. It requires one hour for each 2.5°C increment it's temperature is below 10°C or above 40°C.
Equipment damage possibility. Turning the system on without acclimation after arriving at
site may cause the system to be damaged.
°C
60 55 50 45
°F
140 131 122 113 104
hrs 8 6 4
2–2–4 Checking the Components
When a new system arrives, check that any components are not damaged and are not in short supply. If shipping dam-
age or shortage occurs, contact the address shown in Chapter 1.
CAUTION
TABLE 2–2
TIME FOR SETTLEMENT
40 35 30 25 20 15
95 86 77 68 59
2 0 0 0 0 0
Note
10 5 0 –5 –10 –15 –20 –25 –30 –35 –40
50 41 32 23 14
0 0 2 4 6
2–8
LOGIQ 500 SERVICE MANUAL
P9030TA
5 –4 –13 –22 –31 –40
8 10 12 14 16 18

INSTALLATION

20