Preparing Before Installation - GE LOGIQ 500 Service Manual

GE MEDICAL SYSTEMS
REV 14
6–4–2 Preparing before Installation
1. Turn the system power OFF.
2. Unplug the system. Follow the OSHA Lockout/Tagout Requirements (29 CFR 1910.147, Direction 46–015902).
3. Replace the hard disk with new one if necessary. Refer to sub-section 6–2–70 on page 6–162 for the replacement
procedure of hard disk.
4. Connect the RS232C cable with the serial port of the Laptop PC. Refer to ILLUSTRATION 6–133.
5. Connect the connector of another side with the Service port located at the rear side of the LOGIQ 500 as shown
in ILLUSTRATION 6–133.
You may have to disconnect the insite connection.
6. Plug the system into a dedicated power receptacle.
7. Plug the Laptop PC into a wall outlet.
Note
CHARACTER TERMINAL CONNECTION
ILLUSTRATION 6–133
6–236
LOGIQ 500 SERVICE MANUAL
P9030TA
RENEWAL PARTS