Initializing Hard Disk - GE LOGIQ 500 Service Manual

GE MEDICAL SYSTEMS
REV 14
6–4–3 Initializing Hard Disk (continued)
2. Type the following command and press the return key.
VTSH>mediainit_0.0_PHILE_240000000_20_10000_4000
For the console with software version 4.10 or later, use the following command:
VTSH>mediainit_0.0_PHILE_540000000_20_10000_4000
The character "_" described in operating commands indicates the space.
After 20 minutes, the system completes the formatting of hard disk. The message "***Format Completed***" is
displayed on the screen of Laptop PC.
3. Type the following command and press the return key. The hard disk become valid by entering this command.
VTSH>mount_0.0
6–4–4 Installing Software
1. Insert first floppy disk of the system software floppy disk set into the floppy disk drive of LOGIQ 500. If your sys-
tem has a MO disk drive, insert the appropriate system software MO disk into the MO disk drive of LOGIQ 500.
2. Type the following command and press the return key. Software stored in the floppy disk is copied to the hard disk.
VTSH>cp_–r_1.0/*_0.0/
If your system has a MO disk drive, type the following command and press the return key. The system will start
writing software in the hard disk.
VTSH>cp_–r_2.0/*_0.0/
3. Repeat the above steps 1 and 2 for other disks in the proper sequence. If your system has a MO disk drive, skip
this step.
4. Turn the main switch of the system OFF after completing to write the software into the hard disk.
Note
Note
FLOPPY DISK INSERTION
ILLUSTRATION 6–135
6–238
LOGIQ 500 SERVICE MANUAL
P9030TA
RENEWAL PARTS