Installing Using Mo Disk - GE LOGIQ 500 Service Manual

GE MEDICAL SYSTEMS
REV 14
6–4–6

Installing Using MO Disk

The system software version 2.0 or later console has a MO (Magneto Optical) disk drive. You can use another way to
install the system software into hard disk using the system software MO disk.
1. Make sure that the system power is turned OFF.
2. Insert the system software MO disk into the MO disk drive of LOGIQ 500 console.
3. Turn the system power ON.
LOGIQ 500 system does not perform the ordinary power-up sequence and the message "Now starting the ver-
sion up process!!" is displayed on the CRT monitor screen.
After mounting the MOD drive and checking the system versions of hardware and software, the following mes-
sage will be displayed on the CRT monitor screen.
4. Press the Y key then the system begin to install the system software into the hard disk.
After installing the new system software, the MO disk set in MOD drive is ejected automatically and the LOGIQ
500 system is reset.
5. Follow the sub-section 6–4–5, Final Procedures on page 6–213.
MESSAGE BEFORE BEGINNING INSTALLATION
ILLUSTRATION 6–136
6–240
LOGIQ 500 SERVICE MANUAL
P9030TA
RENEWAL PARTS