Pri Commands (Ld 60) - Avaya CS 1000 Maintenance Manual

Quick reference to PRI operations
Note:
Some cards have a switch on the faceplate to enable and disable the hardware. When
removing a card, first disable the card in software, then disable the hardware by setting the
switch to DIS. Before installing a card, hardware-disable it by setting the switch to DIS. After
the card is locked into position, set the switch to ENB, and then enable the card in software.
Disable and enable cards as described in Avaya Software Input Output Administration,
NN43001-711.

PRI commands (LD 60)

Table 4: PRI commands (quick reference)
PRI commands. For a more extensive list of PRI commands, see the section describing PRI
maintenance.
Table 4: PRI commands (quick reference)
Command
ATLP (0), 1
CDSP
CMIN ALL
CMIN c
DISI loop
DISL loop
DLBK loop
DLBK l ch
DSCH l ch
ENCH loop
ENCH l ch
ENLL loop
LCNT (loop)
LOVF c r
RCNT
RCNT loop
RMST loop
24 ISDN Primary Rate Interface Maintenance
on page 24 is a quick reference list of important
Disable (default) or enable midnight auto loop test.
Clear maintenance display to 00 or blank.
Clear minor alarm indication on all attendant consoles.
Clear minor alarm indication on attendant consoles for
customer c.
Disable loop when all channels are idle.
Disable network and DTI/PRI cards of loop.
Disable remote loop back test per RLBK command.
Disable remote loop back test per RLBK l ch command.
Disable channel ch of loop.
Enable all channels on DTI/PRI.
Enable channel ch of DTI/PRI loop.
Enable network and DTI/PRI cards of loop.
List contents of alarm counters on one or all DTI/PRI
loops.
List threshold overflows for customer c (0-99) and route r
(0-511).
Reset alarm counters of all DTI/PRI loops.
Reset alarm counter of DTI/PRI loop.
Perform self-test on loop.
Comments? infodev@avaya.com
Action
November 2011