Suzuki SY413 Service Manual page 1453

9) Disconnect fan motor wire at coupler.
10) Remove condenser together with fan and receiver/dryer.
NOTE:
Be careful not to damage fins of condenser and radiator.
11) Remove cooling fan and receiver/dryer from condenser.
Installation
Reverse removal sequence to install condenser, noting following
point.
1) When replacing condenser, add 20 to 30 cc of refrigerating oil
from compressor suction-side.
2) Evacuate and charge system according to previously-de-
scribed procedure.
3) Regulate hood latch. Refer to Section 9, "HOOD" in this manual.
C. RECEIVER/DRYER
Inspection
Use a leak tester to check for gas leakage, sight glass and fittings.
Removal
1) Recover refrigerant by using recovery and recycling equip-
ment. Be sure to follow the instruction manual for the equip-
ment.
The amount of compressor oil removed must be measured and
the same amount added to the system.
2) Disconnect liquid line pipes.
3) Remove receiver/dryer from its holder.
1. Receiver/dryer
2. Liquid line pipe
Installation
1) Reverse removal sequence to install receiver/dryer.
NOTE:
D When replacing receiver/dryer, add 10 cc of refrigerating
oil from compressor suction-side.
D Blind plugs of receiver/dryer should not be removed un-
til just before receiver/dryer is installed.
2) Evacuate and charge system according to previously-de-
scribed procedure.
AIR CONDITIONING (OPTIONAL) 1B-19