Chery T21 2014 Service Manual page 26

02 - INTRODUCTION
- Tighten the mounting bolt until the painted area of connector is flush with the surface when installing
connector by tightening bolt.
 Never drop or hit the control module to prevent excessive impact.
 Note that the condensation is not formed on control module due to extreme change of temperature and
keep it free from water drop or rain. If water is found on the control module, dry it thoroughly and then
install it to vehicle.
 Be careful not to allow fluid to adhere to the control module connector.
 Avoid cleaning the control module with volatile fluid.
02
 When using digital multimeter, be careful not to get
the testing probes to contact with each other to result
in a short circuit. Avoid damaging the battery due to
short circuit in power transistor inside the control
module.
 Use specified test adapter to check the input and output signals of control module.
2. Check fuse
 Check that fuse wire is connected.
 If fuse wire is blown, confirm that there is no short in the circuit.
 A fuse with the same rated amperage must be used for replacing.
20
02–
Good Blown
Chery Automobile Co., Ltd.
RT21020210
RT21020220