Alcatel-Lucent 7750 SR Manual page 1196

VPRN Service Configuration Commands
If a CPE connectivity check target address is already being used as the target address in a different
static route, then cpe-check parameters must match. If they do not, the new configuration command
will be rejected.
If a static-route command is issued with no cpe-check target but the destination prefix/netmask and
next-hop matches a static route that did have an associated cpe-check, the cpe-check test will be
removed from the associated static route.
Default No static routes are defined.
Parameters ip-prefix — The destination address of the aggregate route in dotted decimal notation.
netmask — The subnet mask in dotted decimal notation.
ip-int-name — The name of the IP interface. Interface names must be unique within the group of
ip-address — The IP address of the IP interface. The ip-addr portion of the address command
enable — Static routes can be administratively enabled or disabled. Use the enable parameter to re-
disable — Static routes can be administratively enabled or disabled. Use the disable parameter to
Page 1196
Values
ipv4-prefix
ipv4-prefix-length
ipv6-prefix
ipv6-prefix-length
Values
0.0.0.0 — 255.255.255.255 (network bits all 1 and host bits all 0)
defined IP interfaces for config router interface and config service ies interface commands. An
interface name cannot be in the form of an IP address. If the string contains special characters (#,
$, spaces, etc.), the entire string must be enclosed with
specifies the IP host address that will be used by the IP interface within the subnet. This address
must be unique within the subnet and specified in dotted decimal notation.
Values
ipv4-address
ipv6-address
enable a disabled static route. In order to enable a static route, it must be uniquely identified by
the IP address, mask, and any other parameter that is required to identify the exact static route.
The administrative state is maintained in the configuration file.
Default
enable
disable a static route while maintaining the static route in the configuration. In order to enable a
static route, it must be uniquely identified by the IP address, mask, and any other parameter that
is required to identify the exact static route.
The administrative state is maintained in the configuration file.
Default enable
a.b.c.d (host bits must be 0)
0 — 32
x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x: [0 — FFFF]H
d: [0 — 255]D
0 — 128
a.b.c.d (host bits must be 0)
x:x:x:x:x:x:x:x[-interface]
x:x:x:x:x:x:d.d.d.d[-interface]
x: [0..FFFF]H
d: [0..255]D
interface: 32 characters maximum, mandatory for link local
addresses
7750 SR OS Services Guide