Alcatel-Lucent 7750 SR Manual page 1321

Os services guide

Hide thumbs Also See for 7750 SR:

Table of Contents

[no] queue queue-id

config>service>vprn>if>sap>egress>queue-override

config>service>vprn>if>sap>ingress>queue-override

config>service>vprn>ipsec-if>sap>egress>queue-override

config>service>vprn>ipsec-if>sap>ingress>queue-override

This command specifies the ID of the queue whose parameters are to be overridden.

queue-id — The queue ID whose parameters are to be overridden.

adaptation-rule

adaptation-rule [pir adaptation-rule] [cir adaptation-rule]

no adaptation-rule

config>service>vprn>if>sap>egress>queue-override>queue

config>service>vprn>if>sap>ingress>queue-override>queue

config>service>vprn>ipsec-if>sap>egress>queue-override>queue

config>service>vprn>ipsec-if>sap>ingress>queue-override>queue

This command can be used to override specific attributes of the specified queue's adaptation rule

parameters. The adaptation rule controls the method used by the system to derive the operational CIR

and PIR settings when the queue is provisioned in hardware. For the CIR and PIR parameters

individually, the system attempts to find the best operational rate depending on the defined constraint.

The no form of the command removes any explicitly defined constraints used to derive the

operational CIR and PIR created by the application of the policy. When a specific adaptation-rule is

removed, the default constraints for rate and cir apply.

no adaptation-rule

pir — The pir parameter defines the constraints enforced when adapting the PIR rate defined within

cir — The cir parameter defines the constraints enforced when adapting the CIR rate defined within

adaptation-rule — Specifies the criteria to use to compute the operational CIR and PIR values for this

7750 SR OS Services Guide

the queue queue-id rate command. The pir parameter requires a qualifier that defines the

constraint used when deriving the operational PIR for the queue. When the rate command is not

specified, the default applies.

the queue queue-id rate command. The cir parameter requires a qualifier that defines the

constraint used when deriving the operational CIR for the queue. When the cir parameter is not

specified, the default constraint applies.

queue, while maintaining a minimum offset.

Virtual Private Routed Network Services