Alcatel-Lucent 7750 SR Manual page 1013

config>service>ies>if>spoke-sdp>ingress
Description This command associates an IP filter policy filter policy with an ingress or egress spoke SDP.
Filter policies control the forwarding and dropping of packets based on matching criteria.
MAC filters are only allowed on Epipe and Virtual Private LAN Service (VPLS) SAPs.
The filter command is used to associate a filter policy with a specified ip-filter-id with an ingress or
egress spoke SDP. The ip-filter-id must already be defined in the configure>filter context before the
filter command is executed. If the filter policy does not exist, the operation will fail and an error
message returned.
In general, filters applied to SAPs or spoke SDPs (ingress or egress) apply to all packets on the SAP
or spoke SDPs . One exception is non-IP packets are not applied to IP match criteria, so the default
action in the filter policy applies to these packets.
The no form of this command removes any configured filter ID association with the SAP or IP
interface. The filter ID itself is not removed from the system unless the scope of the created filter is
set to local. To avoid deletion of the filter ID and only break the association with the service object,
use scope command within the filter definition to change the scope to local or global. The default
scope of a filter is local.
Special Cases IES — Only IP filters are supported on IES IP interfaces, and the filters only apply to routed traffic.
Parameters
ip — Keyword indicating the filter policy is an IP filter.
ip-filter-id — The filter name acts as the ID for the IP filter policy. Allowed values are an integer in
egress
Syntax egress
Context config>service>ies>if>sap
config>service>ies>sub-if>grp-if>sap
Description This command enables the context to apply egress policies.
If no sap-egress QoS policy is defined, the system default sap-egress QoS policy is used for egress
processing. If no egress filter is defined, no filtering is performed.
ingress
Syntax ingress
Context config>service>ies>if>sap
config>service>ies>sub-if>grp-if>sap
Description
This command enables the context to apply ingress policies.
If no sap-ingress QoS policy is defined, the system default sap-ingress QoS policy is used for ingress
7750 SR OS Services Guide
the range of 1 and 65535 that corresponds to a previously created IP filter policy. The filter ID
must already exist within the created IP filters.
IES Service Configuration Commands
Page 1013