Alcatel-Lucent 7750 SR Manual page 1185

robust-count
Syntax robust-count robust-count
no robust-count
Context config>service>vprn>igmp
Description This command configures the robust count. The robust-count variable allows tuning for the expected
packet loss on a subnet. If a subnet anticipates losses, the robust-count variable can be increased.
Default
2
Parameters
robust-count — Specifies the robust count value.
ssm-translate
Syntax igmp
Context config>service>vprn>igmp
Description This command enables the context to configure group ranges which are translated to SSM (S,G)
entries. If the static entry needs to be created, it has to be translated from a IGMPv1 IGMPv2 request
to a Source Specific Multicast (SSM) join. An SSM translate source can only be added if the starg
command is not enabled. An error message is generated if you try to configure the source command
with starg command enabled.
grp-range
Syntax [no] grp-range start end
Context config>service>vprn>igmp>ssm-translate
Description
This command is used to configure group ranges which are translated to SSM (S,G) entries.
Parameters
start — An IP address that specifies the start of the group range.
end — An IP address that specifies the end of the group range. This value should always be greater
source
Syntax [no] source ip-address
Context config>service>vprn>igmp>ssm-translate>grp-range
Description This command specifies the source IP address for the group range. Whenever a (*,G) report is
received in the range specified by grp-range start and end parameters, it is translated to an (S,G)
report with the value of this object as the source address.
7750 SR OS Services Guide
Values
2 — 10
than or equal to the value of the start value.
Virtual Private Routed Network Services
Page 1185