Alcatel-Lucent 7750 SR Manual page 1190

VPRN Service Configuration Commands
Parameters number — Specifies the maximum number of routes to be held in a VRF context.
log-only — Specifies that if the maximum limit is reached, only log the event. log-only does not
threshold threshold — The percentage at which a warning log message and SNMP trap should be
route-distinguisher
Syntax route-distinguisher [ip-address:number | asn:number]
no route-distinguisher
Context config>service>vprn
Description This command sets the identifier attached to routes the VPN belongs to. Each routing instance must
have a unique (within the carrier's domain) route distinguisher associated with it. A route
distinguisher must be defined for a VPRN to be operationally active.
Default
no route-distinguisher
Parameters
The route distinguisher is a 6-byte value that can be specified in one of the following formats:
ip-address:number — Specifies the IP address in dotted decimal notation. The assigned number must
asn:number — The ASN is a 2-byte value less than or equal to 65535. The assigned number can be
router-id
Syntax router-id ip-address
no router-id
Context config>service>vprn
config>service>vprn>ospf
config>service>vprn>bgp
Description
This command sets the router ID for a specific VPRN context.
If neither the router ID nor system interface are defined, the router ID from the base router context is
inherited.
The no form of the command removes the router ID definition from the given VPRN context.
Default no router-id
Parameters
ip-address — The IP address must be given in dotted decimal notation.
Page 1190
Values
1 — 2147483647
disable the learning of new routes.
sent.
Values 0 — 100
Default 10
not be greater than 65535.
any 32-bit unsigned integer value.
7750 SR OS Services Guide