Alcatel-Lucent 7750 SR Manual page 1417

preference
Syntax preference preference
no preference
Context config>service>vprn>rip
config>service>vprn>rip>group
config>service>vprn>rip>group>neighbor
Description
This command sets the route preference assigned to RIP routes. This value can be overridden by route
policies.
The no form of the command resets the preference to the default.
Default
no preference
Parameters preference — An integer.
propagate-metric
Syntax [no] propagate-metric
Context config>service>vprn>rip
Description This command allows the RIP metric to be used to set the MP-BGP MED attribute when RIP is used
as the CE-PE routing protocols for VPRNs. This is similar to the way the OSPF metric can be used to
set the MP-BGP metric when OSPF is used as the CE-PE protocol.
MP-BGP will use the RIP metric to set the MED attribute, this attribute gets flooded through out the
MP-BGP peers and will then be used to set the RIP metric at the other end and re-advertise the RIP
metric to the far-end RIP neighbors.
receive
Syntax receive {both | none | version-1 | version-2}
no receive
Context config>service>vprn>rip
config>service>vprn>rip>group
config>service>vprn>rip>group>neighbor
Description This command configures the type(s) of RIP updates that will be accepted and processed.
If both or version-2 is specified, the RIP instance listens for and accepts packets sent to the broadcast
and multicast (224.0.0.9) addresses.
If version-1 is specified, the router only listens for and accepts packets sent to the broadcast address.
7750 SR OS Services Guide
Values 1 — 255
Default
100
Virtual Private Routed Network Services
Page 1417