Alcatel-Lucent 7750 SR Manual page 1362

VPRN Service Configuration Commands
rp-candidate
Syntax rp-candidate
Context config>service>vprn>pim>rp
Description This command enables the context to configure the candidate rendezvous point (RP) parameters.
Default
Enabled when PIM is enabled.
group-range
Syntax [no] group-range {grp-ip-address/mask | grp-ip-address [netmask]}
Context config>service>vprn>pim>rp>rp-candidate
config>service>vprn>pim>ssm
Description This command configures the group address or range of group addresses for which this router can be
the rendezvous point (RP).
Use the no form of this command to remove the group address or range of group addresses for which
this router can be the RP from the configuration.
Default
none
Parameters
group-ip-address — Specify the addresses or address ranges that this router can be an RP.
mask — Specify the address mask with the address to define a range of addresses.
netmask — Specify the subnet mask in dotted decimal notation.
holdtime
Syntax holdtime holdtime
no holdtime holdtime
Context config>service>vprn>pim>rp>rp-candidate
Description
Use this command to define the length of time neighboring router consider this router to be up.
Use the no form of this command to revert to the default value.
Default 150
Parameters
holdtime — Specify the length of time, in seconds, that neighbor should consider the sending router to
be operational.
Page 1362
Values 0.0.0.0 — 255.255.255.255 (network bits all 1 and host bits all 0)
Values 0 — 255
7750 SR OS Services Guide