Alcatel-Lucent 7750 SR Manual page 1278

VPRN Service Configuration Commands
mtu
Syntax [no] mtu mtu-bytes
Context config>service>vprn>router-advert>if
Description This command configures the MTU for the nodes to use to send packets on the link.
Default
no mtu — The MTU option is not sent in the router advertisement messages.
Parameters
mtu-bytes — Specify
other-stateful-configuration
Syntax [no] other-stateful-configuration
Description This command sets the "Other configuration" flag. This flag indicates that DHCPv6lite is available
for autoconfiguration of other (non-address) information such as DNS-related information or
information on other servers in the network. See RFC 3736, Stateless Dynamic Host Configuration
Protocol (DHCP) for IPv6.
Default
no other-stateful-configuration
prefix
Syntax [no] prefix [ipv6-prefix/prefix-length]
Context config>service>vprn>router-advert>if
Description
This command configures an IPv6 prefix in the router advertisement messages. To support multiple
IPv6 prefixes, use multiple prefix statements. No prefix is advertised until explicitly configured using
prefix statements.
Default none
Parameters
ip-prefix — The IP prefix for prefix list entry in dotted decimal notation.
prefix-length — Specifies a route must match the most significant bits and have a prefix length.
Page 1278
the MTU for the nodes to use to send packets on the link.
Values
1280 — 9212
Values ipv4-prefix
ipv4-prefix-length
ipv6-prefix
ipv6-prefix-length
Values
1 — 128
a.b.c.d (host bits must be 0)
0 — 32
x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x: [0 — FFFF]H
d: [0 — 255]D
0 — 128
7750 SR OS Services Guide