Alcatel-Lucent 7750 SR Manual page 1325

The defined high-prio-only value cannot be greater than the MBS size of the queue. Attempting to
change the MBS to a value smaller than the high priority reserve will generate an error and fail
execution. Attempting to set the high-prio-only value larger than the current MBS size will also
result in an error and fail execution.
The no form of this command restores the default high priority reserved size.
Parameters
percent — The percent parameter is the percentage reserved for high priority traffic on the queue. If a
mbs
Syntax mbs {size-in-kbytes | default}
no mbs
Context config>service>vprn>if>sap>egress>queue-override>queue
config>service>vprn>ipsec-if>sap>egress>queue-override>queue
Description This command can be used to override specific attributes of the specified queue's MBS parameters.
The MBS is a mechanism to override the default maximum size for the queue.
The sum of the MBS for all queues on an egress access port can oversubscribe the total amount of
buffering available. When congestion occurs and buffers become scarce, access to buffers is
controlled by the RED slope a packet is associated with. A queue that has not exceeded its MBS size
is not guaranteed that a buffer will be available when needed or that the packet's RED slope will not
force the discard of the packet. Setting proper CBS parameters and controlling CBS oversubscription
is one major safeguard to queue starvation (when a queue does not receive its fair share of buffers).
Another is properly setting the RED slope parameters for the needs of services on this port or channel.
If the CBS value is larger than the MBS value, an error will occur, preventing the MBS change.
The no form of this command returns the MBS size assigned to the queue.
Default
default
Parameters
size-in-kbytes — The size parameter is an integer expression of the maximum number of kilobytes of
7750 SR OS Services Guide
value of 10KBytes is desired, enter the value 10. A value of 0 specifies that none of the MBS of
the queue will be reserved for high priority traffic. This does not affect RED slope operation for
packets attempting to be queued.
Values 0 — 100 | default
buffering allowed for the queue. For a value of 100 kbps, enter the value 100. A value of 0 causes
the queue to discard all packets.
Values
0 — 131072 or default
Virtual Private Routed Network Services
Page 1325