Alcatel-Lucent 7750 SR Manual page 1418

VPRN Service Configuration Commands
This control can be issued at the global, group or interface level. The default behavior accepts and
processes both RIPv1 and RIPv2 messages.
The no form of the command resets the type of messages accepted to both.
Default
no receive — Accepts both formats.
Parameters
both — Receive RIP updates in either Version 1 or Version 2 format.
none — Do not accept and RIP updates.
version-1 — Router should only accept RIP updates in Version 1 format.
version-2 — Router should only accept RIP updates in Version 2 format.
send
Syntax send {broadcast | multicast | none | version-1 | both}
no send
Context config>service>vprn>rip
config>service>vprn>rip>group
config>service>vprn>rip>group>neighbor
Description This command specifies the type of RIP messages sent to RIP neighbors. This control can be issued at
the global, group or interface level. The default behavior sends RIPv2 messages with the multicast
(224.0.0.9) destination address.
If version-1 is specified, the router only listens for and accepts packets sent to the broadcast address.
The no form of this command resets the type of messages sent back to the default value.
Default
no send — Sends RIPv2 to the broadcast address.
Parameters
broadcast — Send RIPv2 formatted messages to the broadcast address.
multicast — Send RIPv2 formatted messages to the multicast address.
none — Do not send any RIP messages (i.e. silent listener).
version-1 — Send RIPv1 formatted messages to the broadcast address.
both — Send both RIP v1 & RIP v2 updates to the broadcast address.
timers
Syntax timers update timeout flush
no timers
Context config>service>vprn>rip
config>service>vprn>rip>group
config>service>vprn>rip>group>neighbor
Description
This command sets the values for the update, timeout, and flush timers.
Page 1418
• Update timer — Determines how often RIP updates are sent.
7750 SR OS Services Guide