Alcatel-Lucent 7750 SR Manual page 1040

ETH-CFM Service Commands
backup
Syntax [no] backup ip-address
Context config>service>ies>if>vrrp
Description This command configures virtual router IP addresses for the interface.
bfd-enable
Syntax [no] bfd-enable [base
Context config>service>ies>if>vrrp
Description
This commands assigns a bi-directional forwarding (BFD) session providing heart-beat mechanism
for the given VRRP/SRRP instance. There can be only one BFD session assigned to any given
VRRP/SRRP instance, but there can be multiple SRRP/VRRP sessions using the same BFD session.
BFD control the state of the associated interface. By enabling BFD on a given protocol interface, the
state of the protocol interface is tied to the state of the BFD session between the local node and the
remote node. The parameters used for the BFD are set via the BFD command under the IP interface.
The specified interface may not be configured with BFD; however, when it is, the virtual router will
then initiate the BFD session.
The no form of this command removes BFD from the configuration.
Default
none
Parameters service-id — Specifies the service ID of the interface running BFD.
interface interface-name — Specifies the name of the interface running BFD.
dst-ip ip-address — Specifies the destination address to be used for the BFD session.
init-delay
Syntax init-delay seconds
no init-delay
Context config>service>ies>if>vrrp
Description
This command configures a VRRP initialization delay timer.
Default no init-delay
Parameters seconds — Specifies the initialization delay timer for VRRP, in seconds.
Page 1040
service-id] interface interface-name dst-ip ip-address
|
Values
service-id: 1 — 2147483648
Values
No service ID indicates a network interface.
Values 1 — 65535
7750 SR OS Services Guide