VLL Show Commands
VLL
egress-label
Syntax
egress-label egress-label1 [egress-label2]
Context
show>service
Description
This command displays services using the range of egress labels. If only the mandatory egress-label1
parameter is specified, only services using the specified label are displayed.
If both egress-label1 and egress-label2 parameters are specified, the services using the range of labels
X where egress-label1 <= X <= egress-label2 are displayed.
Use the show router ldp bindings command to display dynamic labels.
Parameters
egress-label1 — The starting egress label value for which to display services using the label range. If
egress-label2 — The ending egress label value for which to display services using the label range.
Output
Show Service Egress Command Output — The following table describes show service
egress label output fields.
Table 27: Show Service Egress Label Output Fields
7750 SR OS Services Guide
only egress-label1 is specified, services only using egress-label1 are displayed.
Values
0, 2049 — 131071
Default
The egress-label1 value.
Values
2049 — 131071
Label
Svc Id
Sdp Id
Type
I. Lbl
E. Lbl
Number of bindings
found
The ID that identifies a service.
The ID that identifies an SDP.
Indicates whether the SDP binding is spoke or mesh.
The VC label used by the far-end device to send packets to this
device in this service by the SDP.
The VC label used by this device to send packets to the far-end
device in this service by the SDP.
The total number of SDP bindings that exist within the specified
egress label range.
VLL Show Commands
Description
Page 1525