Alcatel-Lucent 7750 SR Manual page 1003

tod-suite
Syntax tod-suite tod-suite-name
no tod-suite
Context config>service>ies>if>sap
config>service>ies>sub-if>grp-if>sap
Description This command applies a time-based policy (filter or QoS policy) to the service SAP. The suite name
must already exist in the config>cron context.
Default
no tod-suite
Parameters tod-suite-name — Specifies collection of policies (ACLs, QoS) including time-ranges that define the
host-connectivity-verify
Syntax host-connectivity-verify [source {vrrp | interface}] [interval interval] [action {remove |
alarm}]
Context config>service>ies>if
config>service>ies>sub-if>grp-if
Description This command enables subscriber host connectivity verification for all hosts on this interface. This
tool will periodically scan all known hosts (from dhcp-state) and perform a UC ARP request. The
subscriber host connectivity verification will maintain state (connected vs. not-connected) for all
hosts.
Default
no host-connectivity-verify
Parameters source {interface} — Specifies
interval interval — The interval, in minutes, which specifies the time interval which all known
action {remove | alarm} — Defines the action taken on a subscriber host connectivity verification
7750 SR OS Services Guide
full or partial behavior of a SAP. The suite can be applied to more than one SAP.
verification packets. The interface keyword forces the use of the interface mac and ip addresses.
Note that there are up to 16 possible subnets on a given interface, therefore subscriber host
connectivity verification tool will use always an address of the subnet to which the given host is
pertaining. In case of group-interfaces. one of the parent subscriber-interface subnets (depending
on host's address) will be used.
sources should be verified. The actual rate is then dependent on number of known hosts and
interval.
Values
1 — 6000
Note that a zero value can be used by the SNMP agent to disable host-connectivity-
verify.
failure for a given host. The remove keyword raises an alarm and removes DHCP state and
releases all allocated resources (queues, table entries and etc.). DHCP release will be signaled to
corresponding DHCP server. Static host will never be removed. The alarm keyword raises an
alarm indicating that the host is disconnected.
IES Service Configuration Commands
th
e source to be used for generation of subscriber host connectivity
Page 1003