Configure Path Components - Alcatel-Lucent 7750 SR Manual

Common Configuration Tasks

Configure Path Components

Each CCA is divided into two distinct paths for bandwidth management purposes. One path is
identified as alpha (a) and the other beta (b). The significance of each path for bandwidth
distribution is dependent on the relative path weights each path is given in relationship to the
other. A maximum path rate may also be defined allowing the provisioning of a maximum cap on
the aggregate bandwidth allowed to the SAP or IP interface queues associated with the path.
Each path is separated into three other contexts; SAP-2-SAP (sap-sap), SAP-2-Net (sap-net) and
Net-2-SAP (net-sap). Each path context allows for the definition of the features that are usually
associated with physical ports on other MDAs in the system. These include buffer pool
management, ingress network queue definitions and accounting policy control.
Use the following CLI syntax to provision path components.
•
•
•
Use the following CLI syntax to provision CCAG path components.
CLI Syntax: config>vsm>ccag#
Page 1446
Net SAP
SAP net
SAP SAP
path {a|b}
net-sap
accounting-policy policy-id
collect-stats
egress
pool
mac ieee-address
mtu mtu-bytes
queue-policy queue-policy-name
rate kilo-bits-per-second [aggregate|cca]
sap-net
egress
pool
ingress
pool
mac ieee-address
mtu mtu-bytes
sap-sap
resv-cbs percent-or-default
slope-policy slope-policy-name
resv-cbs percent-or-default
slope-policy slope-policy-name
resv-cbs percent-or-default
slope-policy slope-policy-name
7750 SR OS Services Guide