Alcatel-Lucent 7750 SR Manual page 1115

Configuring a VPRN Interface SAP
VPRN Interface SAP
A SAP is a combination of a port and encapsulation parameters which identifies the service access
VPRN interface
point on the interface and within the SR. Each SAP must be unique within a router. A SAP cannot
be defined if the interface loopback command is enabled.
When configuring VPRN interface SAP parameters, a default QoS policy is applied to each
ingress and egress SAP. Additional QoS policies and scheduler policies must be configured in the
config>qos
explicitly applied to a SAP. There are no default filter policies.
VPRN interface ATM SAP parameters can only be configured on ATM-type MDAs and ATM-
configured ports. The periodic-loopback command can only be enabled when the
config>system>atm>oam
Guide.
Refer to
The following example displays a VPRN interface SAP configuration:
*A:ALA-1>config>service# info
----------------------------------------------
...
...
----------------------------------------------
*A:ALA-1>config>service#
7750 SR OS Services Guide
context. Filter policies are configured in the
context is enabled. See the 7750 SR OS Basic System Configuration
OSPF Configuration Commands on page 1158
vprn 1 customer 1 create
vrf-import "vrfImpPolCust1"
vrf-export "vrfExpPolCust1"
ecmp 8
autonomous-system 10000
route-distinguisher 10001:1
auto-bind ldp
vrf-target target:10001:1
interface "to-ce1" create
address 11.1.0.1/24
sap 1/1/10:1 create
ingress
scheduler-policy "SLA2"
qos 100
exit
egress
scheduler-policy "SLA1"
qos 1010
filter ip 6
exit
exit
exit
static-route 6.5.0.0/24 next-hop 10.1.1.2
spoke-sdp 2 create
exit
no shutdown
exit
Virtual Private Routed Network Services
config>filter
for CLI commands and syntax.
context and must be
Page 1115