Alcatel-Lucent 7750 SR Manual page 1356

VPRN Service Configuration Commands
Parameters value — Specifies the maximum number of groups for this interface.
multicast-senders
Syntax multicast-senders {auto | always | never}
no multicast-senders
Context config>service>vprn>pim>interface
Description
This command configures the way subnet matching is done for incoming data packets on this
interface. An IP multicast sender is an user entity to be authenticated in a receiving host.
Parameters
auto — Subnet matching is automatically performed for incoming data packets on this interface.
always — Subnet matching is always performed for incoming data packets on this interface.
never — Subnet matching is never performed for incoming data packets on this interface.
priority
Syntax priority dr-priority
no priority
Context config>service>vprn>pim>interface
Description This command sets the priority value to become the rendezvous point (RP) that is included in
bootstrap messages sent by the router. The RP is sometimes called the bootstrap router.
The priority command indicates whether the router is eligible to be a bootstrap router.
The no form of the command disqualifies the router to participate in the bootstrap election.
Default
1 (The router is the least likely to become the designated router.)
Parameters dr-priority — Specifies the priority to become the designated router. The higher the value, the higher
sticky-dr
Syntax sticky-dr [priority dr-priority]
no sticky-dr
Context config>service>vprn>pim>interface
Description
This command enables sticky-dr operation on this interface. When enabled, the priority in PIM hellos
sent on this interface when elected as the designateed router (DR) will be modified to the value
configured in dr-priority. This is done to avoid the delays in forwarding caused by DR recovery, when
switching back to the old DR on a LAN when it comes back up.
Page 1356
Values
1 — 16000
the priority.
Values
1 — 4294967295
7750 SR OS Services Guide