Alcatel-Lucent 7750 SR Manual page 1182

VPRN Service Configuration Commands
static
Syntax static
Context config>service>vprn>igmp>interface
Description This command tests forwarding on an interface without a receiver host. When enabled, data is
forwarded to an interface without receiving membership reports from host members.
Default
none
group
Syntax [no] group grp-ip-address
Context config>service>vprn>igmp>interface>static
Description This command adds a static multicast group either as a (*,G) or one or more (S,G) records. Use IGMP
static group memberships to test multicast forwarding without a receiver host. When IGMP static
groups are enabled, data is forwarded to an interface without receiving membership reports from host
members.
When static IGMP group entries on point-to-point links that connect routers to a rendezvous point
(RP) are configured, the static IGMP group entries do not generate join messages toward the RP.
Default
none
Parameters grp-ip-address — Specifies an IGMP multicast group address that receives data on an interface. The
source
Syntax source
Context config>service>vprn>igmp>interface>static>group
Description
This command specifies a IPv4 unicast address that sends data on an interface. This enables a
multicast receiver host to signal a router the group is to receive multicast traffic from, and from the
source(s) that the traffic is expected.
The source command is mutually exclusive with the specification of individual sources for the same
group.
The source command in combination with the group is used to create a specific (S,G) static group
entry.
Use the no form of the command to remove the source from the configuration.
Default
none
Parameters ip-address — Specifies the IPv4 unicast address.
Page 1182
IP address must be unique for each static group. The address must be in dotted decimal notation
7750 SR OS Services Guide