Manual Operation Mode - Mitsubishi Electric MR-JE-*C Instruction Manual

12. WHEN USING WITH A GENERAL-PURPOSE INTERFACE
Note 1. When the rest of command travel distance is other than "0", ST1 (Forward rotation start) is not received. Refer to section
12.6.5 (1).
2. RT (Second acceleration/deceleration selection) will not be accepted during operation. Selection of the servo motor speed and
acceleration/deceleration time constants will be enabled by on-edge of ST1 (Forward rotation start). However, when the rest of
command travel distance is other than "0", ST1 (Forward rotation start) is not enabled even if turned on.
3. Counting will start when the rest of command travel distance becomes "0".
4. When MEND (Travel completion) is off, the station position outputs will be "0" (all off).
5. Up to four points of DO are available; therefore, PS0 to PS7 cannot be outputted simultaneously.

12.6.3 Manual operation mode

For the machine adjustment, home position adjustment, and others, you can shift the position to any position
with the station JOG operation or JOG operation.
(1) Station JOG operation
(a) Setting
Set devices and parameters as shown below depending on the intended application. With this
operation, DI0 (Next station No. selection 1) to DI7 (Next station No. selection 8) are disabled.
Item
Selecting indexer method
Manual operation mode
selection
Station JOG operation
selection
Rotation direction selection
Servo motor speed
Acceleration time constant/
Deceleration time constant
POINT
When the operation mode is changed during operation, inputting ST1 (Forward
rotation start) is disabled until the operation stops. Switch on ST1 (Forward
rotation start) after the operation stops.
Device/parameter to be used
Control mode selection of [Pr. PA01]
MD0 (Operation mode selection 1)
MD1 (Operation mode selection 2)
[Pr. PT27]
SIG (External limit/Rotation direction decision/
Automatic speed selection)
[Pr. PC07]
RT (Second acceleration/deceleration
selection)
Select "_ _ _ 8" (positioning mode (indexer method)).
Switch on MD0.
Switch off MD1.
_ _ 0 _: Select Station JOG operation.
The rotation direction to a station No. will be as
follows.
Off: Station No. decreasing direction
On: Station No. increasing direction
Set a servo motor speed.
1. When RT is turned off
Acceleration time constant: setting value of [Pr.
PC01 Acceleration time constant 1]
Deceleration time constant: setting value of [Pr.
PC02 Deceleration time constant 1]
2. When RT is turned on
Acceleration time constant: setting value of [Pr.
PC30 Acceleration time constant 2]
Deceleration time constant: setting value of [Pr.
PC31 Deceleration time constant 2]
12 - 83
Setting