Mitsubishi Electric MR-JE-*C Instruction Manual page 74

4. PARAMETERS
No./symbol/ Setting
name digit
PT29 Set the DOG polarity.
*TOP3
_ _ _ x _ _ _ x (BIN): Proximity dog input polarity
Function
(HEX) Select the proximity dog input polarity.
selection T-3
0: Dog detection with off
1: Dog detection with on
_ _ _ x (BIN): External limit/Rotation direction input polarity
Select the input polarity of the SIG (External limit/Rotation direction
decision).
0: Normally open contact
1: Normally closed contact
_ _ x _ (BIN): For manufacturer setting
_ x _ _ (BIN): For manufacturer setting
x _ _ _ (BIN): Touch probe 1 input polarity
Select touch probe 1 input polarity.
0: Normally closed contact
1: Normally open contact
_ _ x _ For manufacturer setting
_ x _ _
x _ _ _
Convert the setting value into hexadecimal as follows.
0 0 0
PT30 Set Touch probe sensor - Travel distance before stop.
Upper and lower are a set.
TPSTL
Set an address in hexadecimal.
Touch probe
sensor - When touch probe detection is latched, the remaining travel distance
Travel changes to travel distance set with this parameter.
distance
before stop
Setting address:
(lower four
digits)
PT31
TPSTH
Touch probe
sensor -
The unit can be changed to 10
Travel
setting of [Pr. PT01].
distance
before stop
(upper four
digits)
Setting range: 00000000h to 7FFFFFFFh
Function
Setting
"Proximity dog input polarity" or "External limit/
Rotation direction input polarity"
Touch probe 1 input polarity
Upper four Lower four
digits digits
[Pr. PT30]
[Pr. PT31]
[μm], 10
STM (STM-4)
4 - 37
Initial value
BIN HEX
0
0
0
0
0000h
Refer to
Function
column
for unit.
0000h
Refer to
Function
column
for unit.
[inch], or [pulse] with the
General
Initial
Communication
purpose
value
[unit]
CP PS CP PS
0h
0h
0h
0h
0