Settings For Binary Output - Omron ZW-C1*T User Manual

Settings for Binary Output

Output Content Setting
Output content setting p.146
As an example, here is an explanation of the procedure for outputting the measured value of TASK1 as binary
for each measuring cycle.
Operating procedure
Steps Key operation
1
2
3
4
5
6
7
8
268
Connecting Parallel I/O
Display Description
Press and hold the
Press the
Press the
Press the
Select the binary output contents.
The current set value is displayed on the sub-display.
Press
In this example, select "MEAS1" and press the
Press the
Enable TASK1 binary output.
The current set value is displayed on the sub-display.
Press
Select "ON" and press the
Press and hold the
key for two seconds to enter the FUN mode.
/ keys to select "I/O" and press the
/ keys to select "BINARY" and press the
/ keys to select "OUTPUT" and press the
/ key to enter editing mode and the sub-display blinks.
/ keys to select "TASK1" and press the
/ key to enter editing mode and the sub-display blinks.
key.
key for two seconds to enter the RUN mode.
key.
key.
key.
key.
key.
ZW User's Manual