Setting the Binary Output Cycle
Set the cycle at which binary output is performed. After setting the binary output cycle, the
Controller must be turned OFF then back ON again to enable the settings.
Setting value
1 to 500 (ms)
1
Select the special setting.
Select [SPCL].
Select [IFU] or [ALL].
Confirm the selection.
2
Set the output cycle.
Select [CYCLE].
Change the selection.
Confirm the selection.
ZX-GT User's Manual
Description
Set the output cycle. (default value: 1)
The measurement result is output at the output cycle you set here.
SUB
SUB
Setting Communication Conditions
81