Command List - Omron ZW-C1*T User Manual

Command List

This table lists no-protocol communications commands.
The available commands are listed as follows.
Command Format
name
MS MS <Task number>
<Delimiter>
JG JG <Task number>
<Delimiter>
DG DG <unit number>
<Data number>
<Delimiter>
DS DS <unit number>
<Data number>
<Measured value> <Delimiter>
BG BG <Delimiter>
BS BS <Bank number>
<Delimiter>
ZR ZR <Task number>
<Delimiter>
ZC ZC <Task number>
<Delimiter>
TM TM <0:OFF/ 1:ON>
0<Delimiter>
RT RT <0:OFF/ 1:ON>
0<Delimiter>
LD LD <0: Lit/ 1: Out>
0<Delimiter>
VR VR <Delimiter>
CA CA 0 <Delimiter>
LS LS <Save intervals>
<Number of saves> <Delimiter>
LE LE <Delimiter>
178
No-protocol Connection
*1
Return value Description
<Measured value> Acquires the current measured value.
<Delimiter> If the <task number> is omitted, the
measured value displayed is acquired.
If "4" is set for the <task number>, the
measured values for all tasks are obtained.
<Judgment result> Acquires the judgment result of the specified
<Delimiter> task.
If the <task number> is omitted, the result of
the task of which the result is currently
displayed is acquired.
If "4" is set for the <task number>, the
judgment results for all tasks are obtained.
<Data> Acquires the measurement data and setting
<Delimiter> data of the processing unit.
OK <Delimiter> Change the setting data of the processing
unit.
<Bank number> Acquire the current bank number.
<Delimiter>
OK <Delimiter> Replace the current bank number by the
specified bank number.
OK <Delimiter> Execute a zero reset for the specified task.
If the <task number> is omitted, the zero
reset is executed for the task of which the
result is currently displayed.
If "4" is set for the <task number>, this is
executed for all tasks.
OK <Delimiter> Cancel the zero reset of the specified task.
If the <task number> is omitted, the zero
reset is executed for the task of which the
result is currently displayed.
If "4" is set for the <task number>, this is
executed for all tasks.
OK <Delimiter> Executes TIMING input.
* Calculates OR with the parallel input.
OK <Delimiter> Executes RESET input.
* Calculates OR with the parallel input.
OK <Delimiter> Turns the logical beam ON/OFF.
<Model/Version> Acquire the system version information.
<Delimiter> (Example) ZW-C10 1.100 <Delimiter>
OK <Delimiter> Calibrate the Sensor Head.
OK <Delimiter> Start the internal logging of the data.
OK <Delimiter> End the internal logging of the data.
Pages
p.180
p.181
p.182
p.183
p.184
p.185
p.186
p.187
p.188
p.188
p.189
p.189
p.190
p.190
p.191
ZW User's Manual