Omron ZW-C1*T User Manual page 158

Hold (peak/bottom/peak to peak/average)
TIMING input
(TIMING)
RESET input
(RESET)
Busy output
Judgment output
(HIGH/PASS/LOW)
Binary output
GATE output
Analog output
Item
T3 Response time of analog output
T4 GATE signal rise time
T5 GATE signal output time
T6 TIMING input/RESET input minimum time
T7 Response time of input
Explanation of operations
(1) The TIMING input is turned ON.
(2) During the TIMING input minimum time, when the TIMING input is ON, sampling is started and the BUSY
output is turned ON.
(3) After the end of measurement, the judgment results and binary data are output.
(4) After the TIMING input goes OFF, sampling is ended and the judgment results and binary data are output.
The BUSY output is also turned OFF.
(5) After the judgment result and binary data output, the analog output is updated.
(6) After the judgment result and binary data output, the GATE signal is turned ON.
(7) The GATE signal output time after the GATE output is turned ON, the GATE output is turned OFF.
(8) The GATE signal output is turned ON. During the GATE signal output minimum time, if the GATE signal
output is turned ON, the measured value is reset.
(9) The judgment results and binary data are reset.
(10) After the judgment results and binary data are reset, the analog output is reset.
(11) After the judgment results and binary data are reset, the GATE output is turned ON.
(12) The GATE signal output time after the GATE output is turned ON, the GATE signal is turned OFF.(13) The
RESET input is turned OFF.
(13) The RESET input is turned OFF.
156
Parallel I/O connection
(1) (2) (3)
T7
T6 T7
ON
OFF
ON
OFF
ON
OFF
ON
OFF
(4) (5) (6) (7) (8)
T4
T5
T3
T7
Min.


Setting value
(0.1 to 100.0 ms)
3 ms+T0
2 ms+T0
(9)(10) (11) (12) (13)
T6
T4
T5
T3
Max.
0.1 ms
0.2 ms
Setting value
(0.1 to 100.0 ms)

3 ms+T0×2
ZW User's Manual