Omron ZW-C1*T User Manual page 272

Output cycle setting
Output cycle setting p.148
As an example, here is an explanation of the procedure for setting the output cycle to "2 times" the
measurement cycle.
Operating procedure
Steps Key operation
1 to 3 For moving to "BINARY", see steps 1 to 3 in p.264.
4
5
6
Note
The measuring cycle can be viewed in the "System Information" menu.
Checking Information p.260
GATE signal setting
GATE signal setting p.149
As an example, here is an explanation of the procedure for setting the output time to "100 ms".
Operating procedure
Steps Key operation
1 to 3 For moving to "BINARY", see steps 1 to 3 in p.264.
4
270
Connecting Parallel I/O
Display Description
Press the
Set the output cycle.
The current setting value is displayed on the sub-display.
Press
To edit numerical values, use the
In this example, input "2", then press the
Press and hold the
Display Description
Press the
/ keys to select "CYCLE" and press the
key to enter the editing mode, and the sub-display blinks.
/ /
key for two seconds to enter the RUN mode.
/ keys to select "GATE" and press the
key.
/ keys.
key.
key.
ZW User's Manual